Re: [CAD_CAM_EDM_DRO] Servo types, was EMC step rate configuration
Posted by
Jon Elson
on 2001-01-17 16:25:53 UTC
Tim Goldstein wrote:
with all the features of the Servo-to-Go for much less than they do, and
still make any money at it.
Jon
> That still does not lower the cost to the hobby level as you need a $880We're working on this, too, but it is actually pretty hard to sell something
> motion card.
with all the features of the Servo-to-Go for much less than they do, and
still make any money at it.
Jon
Discussion Thread
John Murphy
2001-01-16 17:51:42 UTC
EMC step rate configuration
Tim Goldstein
2001-01-16 18:41:48 UTC
RE: [CAD_CAM_EDM_DRO] EMC step rate configuration
Carlos Guillermo
2001-01-16 19:24:32 UTC
RE: [CAD_CAM_EDM_DRO] EMC step rate configuration
Jon Elson
2001-01-16 22:35:48 UTC
Re: [CAD_CAM_EDM_DRO] EMC step rate configuration
Tim Goldstein
2001-01-16 22:47:03 UTC
RE: [CAD_CAM_EDM_DRO] EMC step rate configuration
John Murphy
2001-01-17 05:26:21 UTC
Re: [CAD_CAM_EDM_DRO] EMC step rate configuration
Jon Elson
2001-01-17 11:57:37 UTC
Re: [CAD_CAM_EDM_DRO] EMC step rate configuration
Tim Goldstein
2001-01-17 12:48:06 UTC
RE: [CAD_CAM_EDM_DRO] Servo types, was EMC step rate configuration
Jon Elson
2001-01-17 16:25:53 UTC
Re: [CAD_CAM_EDM_DRO] Servo types, was EMC step rate configuration