Re: Any quick requests for DRO software?
Posted by
WAnliker@x...
on 1999-08-01 23:33:07 UTC
In a message dated 8/1/99 9:58:01 PM Pacific Daylight Time,
janders@... writes:
<<
Tom Kulaga wrote:
you to correct a number if you lose it, (power outage). This will also allow
counting down if it happens to be desirable for the job being done. Also you
can dictate what the count display is from any starting point.
One key to select "preset", the selected number should blink or be
highlighted, incrementing thru lsd to msd each time it is pressed, and
another key that will allow the "incrementing" any number that has been
selected to count up one, each time a key is pressed. The count should
continue to increment back thru zero if key is pushed enough times. This
will allow counting down if it happens to be desirable for the job being
done.
If it is easier, one could also just type in a number, to enter it.
Thanks,
bill
janders@... writes:
<<
Tom Kulaga wrote:
> so if you have any suggestions for the DRO software,Please consider the possibility of entering a preset number, thus allowing
> get 'em in now.
>>
you to correct a number if you lose it, (power outage). This will also allow
counting down if it happens to be desirable for the job being done. Also you
can dictate what the count display is from any starting point.
One key to select "preset", the selected number should blink or be
highlighted, incrementing thru lsd to msd each time it is pressed, and
another key that will allow the "incrementing" any number that has been
selected to count up one, each time a key is pressed. The count should
continue to increment back thru zero if key is pushed enough times. This
will allow counting down if it happens to be desirable for the job being
done.
If it is easier, one could also just type in a number, to enter it.
Thanks,
bill
Discussion Thread
Tom Kulaga
1999-08-01 17:53:09 UTC
Any quick requests for DRO software?
Jon Anderson
1999-08-01 21:54:55 UTC
Re: Any quick requests for DRO software?
WAnliker@x...
1999-08-01 23:33:07 UTC
Re: Any quick requests for DRO software?
Laverne Karras
1999-08-02 13:28:40 UTC
Re: Any quick requests for DRO software?
Don Hughes
1999-08-02 14:07:05 UTC
Re: Any quick requests for DRO software?