Need opinion on this motor please........
Posted by
mmueller@n...
on 2001-02-06 13:44:35 UTC
I have access to a few motors of the following specs.
Would these work well for a CNC retrofit on a small Shoptask?
Thanks,
I belive these are DC Servo Motors
Most of these figues I have no idea what they mean:
MOTOR SPECS:
1) MOTOR Kt: 42.43 +/- 10% OZ-IN
2) MOTOR TERM. RES.: 3.56-4.82OHMS
3)MAX TERM VOLTAGE: 90V
4) MAX CONT. SPEED: 2900 (NO LOAD)
5)MAX PEAK TORQUE: 450 OZ-IN
6)MAX PEAK CURRENT: 11.8A
7)MAX CONT. STALL TORQUE: 105 OZ-IN
8)MAX CONT. CURRENT: 2.7A
It has five wires, which I assume are two for the +/- for power and
two for the tach, with one left over(ground?)
Can I use the GeckoDrives for these and if so, which ones.
Thanks
Would these work well for a CNC retrofit on a small Shoptask?
Thanks,
I belive these are DC Servo Motors
Most of these figues I have no idea what they mean:
MOTOR SPECS:
1) MOTOR Kt: 42.43 +/- 10% OZ-IN
2) MOTOR TERM. RES.: 3.56-4.82OHMS
3)MAX TERM VOLTAGE: 90V
4) MAX CONT. SPEED: 2900 (NO LOAD)
5)MAX PEAK TORQUE: 450 OZ-IN
6)MAX PEAK CURRENT: 11.8A
7)MAX CONT. STALL TORQUE: 105 OZ-IN
8)MAX CONT. CURRENT: 2.7A
It has five wires, which I assume are two for the +/- for power and
two for the tach, with one left over(ground?)
Can I use the GeckoDrives for these and if so, which ones.
Thanks
Discussion Thread
mmueller@n...
2001-02-06 13:44:35 UTC
Need opinion on this motor please........
Jon Elson
2001-02-06 15:00:25 UTC
Re: [CAD_CAM_EDM_DRO] Need opinion on this motor please........