Re RE: CNC software for rivet embosser
Posted by
ballendo@y...
on 2001-02-06 14:12:18 UTC
Bill,
Joe gave you some good advice. I'd consider waiting for the windows
DeskNC controller if you're going to use Deskam for toolpath
development. S'posed to be out soon and under 200 bucks.
Hope this helps.
Ballendo
P.S.Be sure to read the list FAQs! VERY useful.
Joe gave you some good advice. I'd consider waiting for the windows
DeskNC controller if you're going to use Deskam for toolpath
development. S'posed to be out soon and under 200 bucks.
Hope this helps.
Ballendo
P.S.Be sure to read the list FAQs! VERY useful.
>You are talking about two separate pieces of software here. The
>CAM makes G-code, and the CONTROLLER takes the G-code and makes
>the motors move.
>Take a look at Deskam <snip>and CNCPro<snip> for your controller.
>Joe V