CAD CAM EDM DRO - Yahoo Group Archive

Re: Good source for MaxNC-10 Belts anyone?

on 2001-02-11 21:54:16 UTC
--- In CAD_CAM_EDM_DRO@y..., Jeff Demand <jdemand@a...> wrote:
> Tracy
>
> Small Parts has some round belting the call Polycord which you cut
to
> length and fuse together. The 1/8" size is 1.29 per foot. A bit of
trial
> and error to get the length and fusing technique right (you learn
both at
> once ;-). I've had one on my unimat for a couple of years and it is
still
> doing well.

I found that Polycord stuff to be an exercise in frustration. Only
got it to fuse together once in about a half dozen tries (well...
maybe a dozen).

Is the belt on the MaxNC an O-ring? McMaster-Carr has lots of them.
For instance: 6" inside diameter, 3/16" thickness, Buna-N rubber -
under $9.00 for 25.

http://www.mcmaster.com/

-Tom Murray

Discussion Thread

tnorris@h... 2001-02-11 08:18:11 UTC Good source for MaxNC-10 Belts anyone? Tim Goldstein 2001-02-11 10:13:53 UTC RE: [CAD_CAM_EDM_DRO] Good source for MaxNC-10 Belts anyone? tauseef 2001-02-11 13:26:02 UTC Re: Good source for MaxNC-10 Belts anyone? Jeff Demand 2001-02-11 15:30:25 UTC Re: Good source for MaxNC-10 Belts anyone? thomasm923@a... 2001-02-11 21:54:16 UTC Re: Good source for MaxNC-10 Belts anyone? Nicholas Carter and Felice Luftschein 2001-02-11 22:06:19 UTC Re: Good source for MaxNC-10 Belts anyone? Ian Wright 2001-02-12 01:23:54 UTC Re: [CAD_CAM_EDM_DRO] Re: Good source for MaxNC-10 Belts anyone?