g-code interpreters
Posted by
jpeter48741@y...
on 2001-02-14 08:49:50 UTC
I own two versions of Maxnc software and Cncpro by Yager Automation.
I've been milling with Camtronics drivers, both stepper and servo, for
several years, having lots of fun. Recently I mounted steppers on a
lathe. I had hoped to use one of the softwares to drive the lathe. I
can't get any of the software to properly read G2 and G3 codes in the
xz
plane. Consequently I've been unable to lathe anything with contours.
Any suggestions would be greatly appreciated.
Thanks,
Jim
jpeter@... <mailto:jpeter@...>
I've been milling with Camtronics drivers, both stepper and servo, for
several years, having lots of fun. Recently I mounted steppers on a
lathe. I had hoped to use one of the softwares to drive the lathe. I
can't get any of the software to properly read G2 and G3 codes in the
xz
plane. Consequently I've been unable to lathe anything with contours.
Any suggestions would be greatly appreciated.
Thanks,
Jim
jpeter@... <mailto:jpeter@...>
Discussion Thread
jpeter48741@y...
2001-02-14 08:49:50 UTC
g-code interpreters
Tim Goldstein
2001-02-14 09:04:22 UTC
RE: [CAD_CAM_EDM_DRO] g-code interpreters
Joe Vicars
2001-02-14 10:09:23 UTC
Re: [CAD_CAM_EDM_DRO] g-code interpreters
Alan Marconett KM6VV
2001-02-14 11:07:05 UTC
Re: [CAD_CAM_EDM_DRO] g-code interpreters