Re: [CAD_CAM_EDM_DRO] g-code interpreters
Posted by
Joe Vicars
on 2001-02-14 10:09:23 UTC
Yea,
If X and Z is your problem just post in X and Y and switch the drivers to correspond with those axes. But CNCPro should have no
problem with circular interpolation in any plane.
It sounds like a post processor problem to me.
If X and Z is your problem just post in X and Y and switch the drivers to correspond with those axes. But CNCPro should have no
problem with circular interpolation in any plane.
It sounds like a post processor problem to me.
Discussion Thread
jpeter48741@y...
2001-02-14 08:49:50 UTC
g-code interpreters
Tim Goldstein
2001-02-14 09:04:22 UTC
RE: [CAD_CAM_EDM_DRO] g-code interpreters
Joe Vicars
2001-02-14 10:09:23 UTC
Re: [CAD_CAM_EDM_DRO] g-code interpreters
Alan Marconett KM6VV
2001-02-14 11:07:05 UTC
Re: [CAD_CAM_EDM_DRO] g-code interpreters