Re: [CAD_CAM_EDM_DRO] Re: Newby- Again and My First Home Brew Project.

Ballendo,

Are you thinking of frog??

http://www.miclog.com/frog/

Alan KM6VV

ballendo@... wrote:

>
> Bruce,List,
>
> Not familiar with them, but they are at:
>
> http://www.steppercontrol.com
>
> (snips, inserts below)
>
> >My first question is, who
> > makes a good lathe control program?
>
> AhHa! and microkinetics seem to be the only lower- end lathe control
> programs. Some people on this list are using mill programs for their
> lathe(s). AhHa is GOOD, microkinetics is a lathe program, IMO.
>
> A relative newcomer is the single axis "threading capable" powerfeed
> known as the "???". My mind just went completely blank :-( designed
> for smaller lathes, it may be an easy way to add threading to a "mill
> program run" lathe. still don't remember... Help!
>
> Hope this helps.
>
> Ballendo
>
> >Next question, does anybody have any
> > experience with Stepper Controls .com's products? Their products
> seem very
> > reasonably priced. Any other good sources?
> >Bruce