Re: Water Jet

What does a waterjet cutting machine run? I would suspect that if they are
the abrasive type they probably run $50K. For just the waterjet portion.
-----Original Message-----
From: TheDragonPit <dragonpit@...>
To: CAD_CAM_EDM_DRO@onelist.com <CAD_CAM_EDM_DRO@onelist.com>
Date: Sunday, August 08, 1999 5:37 AM
Subject: [CAD_CAM_EDM_DRO] Water Jet

>From: "TheDragonPit" <dragonpit@...>
>
>Hello every buddy been lurking for few days trying to decide if I want to

set up linux maybe, I've done it a few times but its been a while, well on
to the point. I run a small welding shop here in Texas where I have a built
a cutting torch, and a small router

>that I've been running with Stepster. I was looking into setting up a

laser to do cutting with but have since decide to go with water jet. Just
thought I'd throw the option out there for thought.

>Henry Bawcum
>
>[Attachments have been removed from this message]
>
>--------------------------- ONElist Sponsor ----------------------------
>
>GET WHAT YOU DESERVE! A NextCard Platinum VISA: DOUBLE Rewards points,
> NO annual fee & rates as low as 9.9 percent FIXED APR.
>Apply online today! http://www.onelist.com/ad/nextcard1
>
>------------------------------------------------------------------------
>Welcome to CAD_CAM_EDM_DRO@...,an unmodulated list for the

discussion of shop built systems in the above catagories.

>To Unsubscribe, read archives, change to or from digest.
>Go to: http://www.onelist.com/isregistered.cgi
>Log on, and you will go to Member Center, and you can make changes there.
>bill,
>List Manager
>