CAD CAM EDM DRO - Yahoo Group Archive

Re: Quick RF-45/VFD question

Posted by andy@o...
on 2001-03-01 08:38:17 UTC
I am pretty sure my VFD manual specifically said not to put any
switches between the motor and drive. For a surplus seller of VFDs
try http://www.dealerselectric.com . No relationship, satisfied
customer etc. Andy



> Second question is if anyone out there using a VFD still uses
> the power switch on the mill to switch/reverse the power to the
> motor. According to the nice tech at AutomationDirect I could
> rewire the switch on the mill to control one of the inputs on
> the VFD to accomplish the same thing but I don't know if I want
> to start tearing into the mill right at the start :-)
>
> Thanks,
> Drew
>
> --
> Drew Rogge
> drew@p...

Discussion Thread

Drew Rogge 2001-03-01 08:20:27 UTC Quick RF-45/VFD question Jon Anderson 2001-03-01 08:36:57 UTC Re: [CAD_CAM_EDM_DRO] Quick RF-45/VFD question andy@o... 2001-03-01 08:38:17 UTC Re: Quick RF-45/VFD question Carlos Guillermo 2001-03-01 08:41:44 UTC RE: [CAD_CAM_EDM_DRO] Quick RF-45/VFD question tmay@u... 2001-03-01 14:33:01 UTC Re: Quick RF-45/VFD question ptengin@a... 2001-03-01 14:35:24 UTC Re: [CAD_CAM_EDM_DRO] Re: Quick RF-45/VFD question ptengin@a... 2001-03-01 14:43:30 UTC Re: [CAD_CAM_EDM_DRO] Re: Quick RF-45/VFD question Drew Rogge 2001-03-05 09:57:11 UTC Re: [CAD_CAM_EDM_DRO] Quick RF-45/VFD question ptengin@a... 2001-03-05 11:15:48 UTC Re: [CAD_CAM_EDM_DRO] Quick RF-45/VFD question