Re: [CAD_CAM_EDM_DRO] Bleed resistor question.

Jason,

Yes, Just wire it across one of the capacitors. It just needs to go from
the hot side to ground.

Bob Campbell

----- Original Message -----
From: <andesign2@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Thursday, March 08, 2001 3:36 PM
Subject: [CAD_CAM_EDM_DRO] Bleed resistor question.


> In the power supply I am building I have used two capacitors in
> parallel to get the rating I need. I have purchased a resistor to
> use as a bleed, but I am not quite sure how to wire it up. Can I
> simply wire it across one of the capacitors? Any information would be
> appreciated.
>
> Thank You,
>
> Jason
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>