Re: [CAD_CAM_EDM_DRO] Bleed resistor question.
Posted by
Jon Elson
on 2001-03-08 15:26:31 UTC
andesign2@... wrote:
that is in parallel with the other capacitor, then the resistor bleeds both
down to zero.
Jon
> In the power supply I am building I have used two capacitors inYes, that should be fine. If it is in parallel with one capacitor, and
> parallel to get the rating I need. I have purchased a resistor to
> use as a bleed, but I am not quite sure how to wire it up. Can I
> simply wire it across one of the capacitors? Any information would be
> appreciated.
that is in parallel with the other capacitor, then the resistor bleeds both
down to zero.
Jon
Discussion Thread
andesign2@y...
2001-03-08 13:36:18 UTC
Bleed resistor question.
Bob Campbell
2001-03-08 15:00:57 UTC
Re: [CAD_CAM_EDM_DRO] Bleed resistor question.
Jon Elson
2001-03-08 15:26:31 UTC
Re: [CAD_CAM_EDM_DRO] Bleed resistor question.
Alan Marconett KM6VV
2001-03-08 16:25:19 UTC
Re: [CAD_CAM_EDM_DRO] Bleed resistor question.
Hugh Prescott
2001-03-09 06:56:41 UTC
Re: [CAD_CAM_EDM_DRO] Bleed resistor question.
Alan Marconett KM6VV
2001-03-09 10:56:54 UTC
Re: Bleed resistor question.