CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Bleed resistor question.

on 2001-03-08 16:25:19 UTC
Hi Jason,

If the two caps are in parallel, you can put the bleeder resistor across
either cap. Just make sure it won't touch anything, as it will get HOT!

Alan KM6VV


andesign2@... wrote:
>
> In the power supply I am building I have used two capacitors in
> parallel to get the rating I need. I have purchased a resistor to
> use as a bleed, but I am not quite sure how to wire it up. Can I
> simply wire it across one of the capacitors? Any information would be
> appreciated.
>
> Thank You,
>
> Jason

Discussion Thread

andesign2@y... 2001-03-08 13:36:18 UTC Bleed resistor question. Bob Campbell 2001-03-08 15:00:57 UTC Re: [CAD_CAM_EDM_DRO] Bleed resistor question. Jon Elson 2001-03-08 15:26:31 UTC Re: [CAD_CAM_EDM_DRO] Bleed resistor question. Alan Marconett KM6VV 2001-03-08 16:25:19 UTC Re: [CAD_CAM_EDM_DRO] Bleed resistor question. Hugh Prescott 2001-03-09 06:56:41 UTC Re: [CAD_CAM_EDM_DRO] Bleed resistor question. Alan Marconett KM6VV 2001-03-09 10:56:54 UTC Re: Bleed resistor question.