Re:Re Dremel
Posted by
Bradford Chaucer
on 2001-03-14 17:45:46 UTC
At 04:07 PM 3/14/2001, you wrote:
I have one complaint/suggestion. How about adding a couple of additional
speeds at the low end? They seem to go down to 5000 as the minimum
speed. That is really too fast for drilling and cutting in plastic. It
tends to melt the plastic. We really need a low speed model that goes down
below 1000. I tend to use a Foredom flex shaft because I can get them far
slower than the Dremel does.
Regards,
Bradford Chaucer
bradford.chaucer@...
>Any further comments from frequent Dremel users?Yes, are you affiliated with Dremel??
>
>Peter
I have one complaint/suggestion. How about adding a couple of additional
speeds at the low end? They seem to go down to 5000 as the minimum
speed. That is really too fast for drilling and cutting in plastic. It
tends to melt the plastic. We really need a low speed model that goes down
below 1000. I tend to use a Foredom flex shaft because I can get them far
slower than the Dremel does.
Regards,
Bradford Chaucer
bradford.chaucer@...