Bad Vibes, RFI?

Hello all
My boys and I are putting together a 4 axis CNC mod of one of those
evil, wicked, mean, and nasty, pinko-commie conspiracy bred combo-
machines. ;) As total newbies on this stuff, we are wondering if
anyone out there has run across any RFI or whatever problems caused
by long wire runs to the servo motors. We are using Camtronic
supplied servo motors, Dan's case and parts kit, with Gecko 320
drives. Computers will not be a problem as the slowest we have in
our homebrew pile is a P-350 'celery', with lots of RAM and running
Vector and VCarvz.
Eventually, we will be making a large CNC router table of one sort or
another and we would like to experiment with using same control box
setup and just switching the wire bundles as needed for each
setup...the combo will be in an adjacent room from the router. (that
is if the electronic differences for each system do not make
adjustments too much of a problem each time.)

Thanks one and all for sharing advice on this group. Doing business
with Camtronics, Geckodrive, and IMServe has been easy and all
involved have been as helpful as several of you have pointed out.

Marc & boyz
from the bushes in Oregon