Re: [CAD_CAM_EDM_DRO] Re: Bad Vibes, RFI?

Jeff, Marc,

I live in Portland...so that makes three in OR.

Ciao,

Craig

sorensen@... wrote:

>
> Jeff
> I am from Ashland area. I would love to compare notes soon as I get
> a little more time. Reply off-line for phone number, and specifics,
> etc.
> Also, looks like you and I are not the only Oregonians on this list.
>
> I am trying to anticipate problems associated with taking a one-box
> approach to a router in one room and metal mangler in another. I
> still have a fair amount of learning to do on some basics, but that
> is one reason why the boyz and I are taking all this on as a project.
>
> thanx
> Marc and boyz
>
> --- In CAD_CAM_EDM_DRO@y..., cadman@p... wrote:
> > <Snip>
> > > Marc & boyz
> > > from the bushes in Oregon
> >
> >
> > Where is Oregon are you? I too am in Oregon and have taken the
> same
> > route with the Camtronics Gecko box and Dan's servo motors. I have
> > not built the box yet so if I have questions and you live close to
> > me.....Well....
> >
> >
> > Jeff aka CADMAN
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/