Re: digital to analog
Posted by
carlcnc@s...
on 2001-03-31 20:11:07 UTC
--- In CAD_CAM_EDM_DRO@y..., "Tim Goldstein" <timg@k...> wrote:
somehow I 'Knew" this question would come up.!
Look in the archives for Xynetics Plotter
After talking with the guys at Applied Motion Products I discovered
that this unit has linear bi-polar steppers!
The hitch is that [believe it or not] the motors are driven by 150V
8a .Originally designed and hooked to HP 3000 ,I have everything but
the computer,
Now it gets beyond me: drivers accept analog input via a d/a
converter card!that was installed in the computer[that I don't have]
Actually ,I asked the same question, why would any engineer put
analog between two digital devices?
They did,in 1987 when this unit was built.
I could run the motors with Geckos but thought it would be worth
trying to use the 150V drives as is.
Carl
> What is an analog input stepper driver??Tim
>
> Tim
> [Denver, CO]
>
somehow I 'Knew" this question would come up.!
Look in the archives for Xynetics Plotter
After talking with the guys at Applied Motion Products I discovered
that this unit has linear bi-polar steppers!
The hitch is that [believe it or not] the motors are driven by 150V
8a .Originally designed and hooked to HP 3000 ,I have everything but
the computer,
Now it gets beyond me: drivers accept analog input via a d/a
converter card!that was installed in the computer[that I don't have]
Actually ,I asked the same question, why would any engineer put
analog between two digital devices?
They did,in 1987 when this unit was built.
I could run the motors with Geckos but thought it would be worth
trying to use the 150V drives as is.
Carl
> > What can I use to get my step and direction signals fro m paralell
> > port to control an analog input stepper drive?
> >
> > CB
> >
> > FAQ: http://www.ktmarketing.com/faq.html
Discussion Thread
carlcnc@s...
2001-03-31 19:06:00 UTC
digital to analog
Tim Goldstein
2001-03-31 19:14:40 UTC
RE: [CAD_CAM_EDM_DRO] digital to analog
JanRwl@A...
2001-03-31 20:05:40 UTC
Re: [CAD_CAM_EDM_DRO] digital to analog
carlcnc@s...
2001-03-31 20:11:07 UTC
Re: digital to analog
Jon Elson
2001-03-31 21:07:32 UTC
Re: [CAD_CAM_EDM_DRO] Re: digital to analog
Alan Marconett KM6VV
2001-04-01 14:46:06 UTC
Re: [CAD_CAM_EDM_DRO] digital to analog
carlcnc@s...
2001-04-01 16:38:15 UTC
Re: digital to analog
Jon Elson
2001-04-01 23:45:36 UTC
Re: [CAD_CAM_EDM_DRO] digital to analog
kleinbauer@j...
2001-04-02 05:09:09 UTC
Re: digital to analog
mariss92705@y...
2001-04-02 08:02:41 UTC
Re: digital to analog
Alan Marconett KM6VV
2001-04-02 12:08:03 UTC
Re: digital to analog
Tom Eldredge
2001-04-03 04:26:28 UTC
Re: [CAD_CAM_EDM_DRO] Re: digital to analog