Re: digital to analog

Hi,

I took a quick look at the circuit shown in the below link. The
servos refered to are commonly used in radio-controlled model
aircraft. The interface circuit synthesizes the signal the RC
receiver generates to operate those servo actuators. Perhaps that is
what was meant by "analog input servo drives"

Mariss

--- In CAD_CAM_EDM_DRO@y..., kleinbauer@j... wrote:
> Check out this link:
>
> http://www.geocities.com/SiliconValley/Lakes/7156/articl4.htm
>
>
>
> --- In CAD_CAM_EDM_DRO@y..., carlcnc@s... wrote:
> > What can I use to get my step and direction signals fro m
paralell
> > port to control an analog input stepper drive?
> >
> > CB