Re: [CAD_CAM_EDM_DRO] Re: digital to analog

Mariss,

Are you going to Names? I think you should, and I hope you do.

Tom Eldredge

----- Original Message -----
From: <mariss92705@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Monday, April 02, 2001 10:02 AM
Subject: [CAD_CAM_EDM_DRO] Re: digital to analog


> Hi,
>
> I took a quick look at the circuit shown in the below link. The
> servos refered to are commonly used in radio-controlled model
> aircraft. The interface circuit synthesizes the signal the RC
> receiver generates to operate those servo actuators. Perhaps that is
> what was meant by "analog input servo drives"
>
> Mariss
>
>
> --- In CAD_CAM_EDM_DRO@y..., kleinbauer@j... wrote:
> > Check out this link:
> >
> > http://www.geocities.com/SiliconValley/Lakes/7156/articl4.htm
> >
> >
> >
> > --- In CAD_CAM_EDM_DRO@y..., carlcnc@s... wrote:
> > > What can I use to get my step and direction signals fro m
> paralell
> > > port to control an analog input stepper drive?
> > >
> > > CB
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>
>