CAD CAM EDM DRO - Yahoo Group Archive

Re: Re: Encoders - API??? (possibly of interest only to programmers)

Posted by Ray
on 2001-04-05 09:39:06 UTC
From: Alan Marconett KM6VV <KM6VV@...>
Subject: Re: Encoders - API??? (possibly of interest only to programmers)

Hi,

<s>but if you are implementing a counter in the PIC, then the PIC would
>have to know which direction too! I guess you could run a line from the
>direction line going to each driver (step/dir).

You could stack two pulse generators for each axis with outputs offset for
quad but the hardware to do this may offset the cost advantage.

Ray

Discussion Thread

The AntiYuppie 2001-04-04 22:24:34 UTC Encoders - API??? (possibly of interest only to programmers) Larry Edington 2001-04-05 00:21:12 UTC Re: [CAD_CAM_EDM_DRO] Encoders - API??? (possibly of interest only to programmers) Tony Jeffree 2001-04-05 00:30:47 UTC Re: Encoders - API??? (possibly of interest only to programmers) Ray 2001-04-05 09:39:06 UTC Re: Re: Encoders - API??? (possibly of interest only to programmers) Hugh Prescott 2001-04-05 10:12:15 UTC Re: [CAD_CAM_EDM_DRO] Re: Re: Encoders - API??? (possibly of interest only to programmers) mariss92705@y... 2001-04-05 10:28:12 UTC Re: Encoders - API??? (possibly of interest only to programmers) Hugh Prescott 2001-04-05 16:07:24 UTC Re: [CAD_CAM_EDM_DRO] Re: Encoders - API??? (possibly of interest only to programmers)