Re: Table for RF-45 - an idea and optimum height?
Posted by
mycomminc@a...
on 2001-04-08 15:18:23 UTC
--- In CAD_CAM_EDM_DRO@y..., Drew Rogge <drew@p...> wrote:
plywood, top, bottom, and between layers, construction adhesive, and
threaded rod inside the hollow blocks from top to bottom at the
corners to clamp it all together. A sheet of steel with raised rolled
edges on top will finish it. A very small amount of adhesive will be
used to allow for future disassembly. I may add weight to the bottom
also.
To All; I assume that there is an optimum height for the
milling table based on the users height. How is this figure arrived
at?
Rick Brown
>Drew; I am going to build one using layers of cinder blocks,
> Before I go out and either have one made or make one myself, does
> anyone know of a stout commercialy available table/stand which will
> work well with a RF-45?
plywood, top, bottom, and between layers, construction adhesive, and
threaded rod inside the hollow blocks from top to bottom at the
corners to clamp it all together. A sheet of steel with raised rolled
edges on top will finish it. A very small amount of adhesive will be
used to allow for future disassembly. I may add weight to the bottom
also.
To All; I assume that there is an optimum height for the
milling table based on the users height. How is this figure arrived
at?
Rick Brown
Discussion Thread
Drew Rogge
2001-04-06 10:33:54 UTC
Table for RF-45
Jerry Kimberlin
2001-04-06 17:15:10 UTC
Re: [CAD_CAM_EDM_DRO] Table for RF-45
ptengin@a...
2001-04-08 00:48:02 UTC
Re: [CAD_CAM_EDM_DRO] Table for RF-45
mycomminc@a...
2001-04-08 15:18:23 UTC
Re: Table for RF-45 - an idea and optimum height?
Drew Rogge
2001-04-09 09:47:58 UTC
Re: [CAD_CAM_EDM_DRO] Table for RF-45
Carlos Guillermo
2001-04-09 10:44:40 UTC
RE: [CAD_CAM_EDM_DRO] Table for RF-45
Drew Rogge
2001-04-09 10:49:35 UTC
Re: [CAD_CAM_EDM_DRO] Table for RF-45
Jerry Kimberlin
2001-04-09 20:57:02 UTC
Re: [CAD_CAM_EDM_DRO] Table for RF-45