Re: [CAD_CAM_EDM_DRO] Check out http://www.users.qwest.net/~kmaxon/page/home.html

Kenneth is fine, as Mr part implies that I know something. The hard
dose of reality is that I like everybody else am still learning (and hope to
be for the rest of my life) Thanks for the praise anyhow and glad you
enjoyed the site.
What can I tell you about the encoders? Are you refering to the linear
encoders on my Mill or some of the others on the page?

-Kenneth
(Unit 3's in trouble and it's scared out of its wits) -Geddy Lee

----- Original Message -----
From: <wanliker@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Thursday, April 19, 2001 7:32 PM
Subject: [CAD_CAM_EDM_DRO] Check out
http://www.users.qwest.net/~kmaxon/page/home.html


> <A HREF="http://www.users.qwest.net/~kmaxon/page/home.html">Click here:
> http://www.users.qwest.net/~kmaxon/page/home.html</A>
>
> This site was pointed out a short while back, and I would highly recommend
> that all take a look at it, as you will see it is robotic in nature, but
our
> machines are also robotic in nature. There is a tremendous amount of
> knowledge available there.
> I hope that there will be more details on the encoder struts soon.
> Mr. Kenneth Maxon, is a new and still lurking member on the list, and hope
> that he finds something of interest here. I know that I did on his site.
> bill
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>