RE: [CAD_CAM_EDM_DRO] Re:PIC Programming

When I was just starting with the PIC, I used the book Easy PIC'n by David
Benson. Although I have done a lot of assembly with other computers, this
got me started with the PIC. He starts simple and ramps up slowly. Takes
him 75 pages to work up to turning a LED off and on with a switch. Then Myke
Predko's book (second edition) really covers the subject.

Dennis
P.S I just picked up Myke Predko's matching book 'Programming and
Customizing the 8051 Microcontroller' Very complete (no PC board though)


-----Original Message-----
From: wanliker@... [mailto:wanliker@...]
Sent: Saturday, April 21, 2001 6:26 PM
To: CAD_CAM_EDM_DRO@yahoogroups.com
Subject: Re: [CAD_CAM_EDM_DRO] Re:PIC Programming


In a message dated 4/21/01 3:32:01 PM Mountain Daylight Time,
ronginger@... writes:

<< There is a good book PROGRAMMING AND CUSTOMIZING PICmicro
MICROCONTROLLERS, by Myke Predko.
Pubilshed by McGraw-Hill, ISBN 0-07-136172-3

>>

What programing language is he using?
bill

Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.

Addresses:
Post message: CAD_CAM_EDM_DRO@yahoogroups.com
Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
Moderator: jmelson@... timg@... [Moderator]
URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
bill,
List Manager

FAQ: http://www.ktmarketing.com/faq.html

Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/