Re: [CAD_CAM_EDM_DRO] PC board making

Hi Larry,

I tried this stuff but didn't have much success with it. Apart from having
to use whole A4 sheets for even a small PC board to get them through the
laser printer and the quite high cost of the product, I had a couple of
failures where it didn't seem to adhere to the PC board completely - perhaps
I hadn't degreased quite well enough but it was an expensive lesson to
learn. You also need to be a bit careful that you use a good brand - I
acquired some 'surplus' stuff and the first sheet stuck to the heater roller
in the laser printer - took me the best part of a week to get it clean!!!

Ian
--
Ian W. Wright
Sheffield UK
www.iw63.freeserve.co.uk

----- Original Message -----

> If you have a laser printer, try the "Press-n-Peel" Blue stuff.
>
> http://www.techniks.com/press-n-peel.html
>