Re: [CAD_CAM_EDM_DRO] 6 wire stepper

JACK,
I just received a bunch of Fuji Elec. Co. motors with those colors and
about the same resistance readings. I ran them from a Camtronics board
just fine. Swap a pair of wires to a coil if you want it to run the
other way.
My only ? is what is the torque rating? Fuji stepper info seems to be
non-existant. Anybody know of a source?
Rich D.

Jack Ensor wrote:

>
> >From your resistance readings, I would say that white is the center
> tap on the one winding and black is the center tap on the other
> winding.
>
> Jack Ensor
>
> marble_h@... wrote:
> >
> > ok now lets see if I have it right i have six wires coming out of
> > the stepper
> >
> > Black
> > Blue
> > Red
> > White
> > Green
> > yellow
> >
> > white/green and yellow Black /Blue and Red
> >
> > White/ yellow = 1.1 ohms Black /Blue = 1.1 ohms
> > white /Green = 1.1 ohms Black /Red = 1.1 ohms
> > green /Yellow = 1.6 ohms Blue /red = 1.5 ohms
> >
> > wht ,yel /grn 3.2 ohms Blk,red /blue =3.0 0hms
> > wht grn /yel = 3.0 ohms Blk,Blu / Red =3.0 ohms
> > yel ,grn/wht = 2.7 ohms red,Blue/ Black =2.7 ohms
> >
> > does it matter what one I use as a common wire between the stators
> > Can I use YELLOW for one and the BLACK for the other .