CAD CAM EDM DRO - Yahoo Group Archive

Rich's penholder

Posted by Peter Chen
on 2001-04-26 17:46:51 UTC
From: "Rich D." <cmsteam@...> "It didn't occur
to me that someone would think that the spindle should
be rotated to use the plotting pen. :-o) There is
more than enough drag in the spindle drive to prevent
the pen from turning which, if you think about it, is
quite impossible as it is (should be) on the center
axis."

Pen tip may be off center. Anyway, is there a locking
mechanism on your spindle. Thanks

Peter


____________________________________________________________
Do You Yahoo!?
Get your free @... address at http://mail.yahoo.co.uk
or your free @... address at http://mail.yahoo.ie

Discussion Thread

Peter Chen 2001-04-26 12:27:36 UTC Rich's penholder Peter Chen 2001-04-26 13:31:33 UTC Rich's penholder Rich D. 2001-04-26 16:27:54 UTC Re: [CAD_CAM_EDM_DRO] Rich's penholder Peter Chen 2001-04-26 17:46:51 UTC Rich's penholder ballendo@y... 2001-04-26 18:12:23 UTC Re: Rich's penholder