Re: [CAD_CAM_EDM_DRO] Multiple G320s

I'll take a copy of this if you will, I bought 3 drives a couple of months ago and was at the point of being able to wire them.
Bob KB1FRW mcamp@...

mariss92705@... wrote:

> Hi,
>
> I've come up with a simple circuit for operating multiple G320/G340s.
> Here's what it does:
>
> 1) If one drive "faults" it automatically shuts down all the others.
> 2) It sends an opto-isolated signal back to the PC of a "fault"
> 3) It sends a signal back to the PC when the drives are ready to go.
> 4) A PC can enable or reset all drives via an opto-isolated input.
> 5) A single contol wire goes out to all the drives to do this.
> 6) You don't have to hold an "enable" switch for 5 sec.
>
> If anyone is interested, contact me off-list and I will e-mail you
> the circuit diagram, or with permission I can post it in the "files"
> section as a .pdf.
>
> Mariss
>
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/