Re: [CAD_CAM_EDM_DRO] Recommend system for EMC

I am going to try on a P200
hard drive and ram?
Video card? I have heard that there are some video cards to stay away from.



Tim Goldstein wrote:

> My EMC experience says it depends. Jon Elson tells us his servo based EMC
> system runs great on a Pentium Classic 100. My experience with the stepper
> versions say that you need a little more processor power. If you are running
> steppermod a 200 mhz system seems to be about the minimum. If running
> freqmod then a 333 or better seems to be more appropriate. If you need
> really high pulse rates increase by 50%.
>
> Your Mileage May Vary
>
> Tim
> [Denver, CO]
>
> > -----Original Message-----
> > what are the "minimum system requirements" to run the EMC BDI?
> >
> >
> > FAQ: http://www.ktmarketing.com/faq.html
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/