Re: [CAD_CAM_EDM_DRO] Replace Heidenhein w/ EMC?

"Sven Peter, TAD S.A." wrote:

> so you might give it a shot to get it running as it is.

Oh it's running now, but he's not sure he likes the interface. He's seen
my Ahha setup and likes the way I can go in and edit programs full
screen either in Ahha's editor or DOS Edit. EMC offers pretty much the
same. While converting to EMC might result in further hair loss for both
of us, it'd most probably come out cheaper than having a service tech
drive out to the middle of nowhere. It's sort of a back up plan if the
control does die.
Thanks for the input.

Jon