Re: [CAD_CAM_EDM_DRO] Replace Heidenhein w/ EMC?
Posted by
Sven Peter, TAD S.A.
on 2001-05-08 08:41:54 UTC
Hello Jon,
So you deal with an old monster package.
If you have already experience in conversions possibly
you are better of not to fool with old stuff that you do not trust.
In most cases the back up will not work because the kids start
to play Star War with it.
Good Luck
Sven Peter
Jon Anderson wrote:
So you deal with an old monster package.
If you have already experience in conversions possibly
you are better of not to fool with old stuff that you do not trust.
In most cases the back up will not work because the kids start
to play Star War with it.
Good Luck
Sven Peter
Jon Anderson wrote:
> "Sven Peter, TAD S.A." wrote:[Non-text portions of this message have been removed]
>
> > so you might give it a shot to get it running as it is.
>
> Oh it's running now, but he's not sure he likes the interface. He's seen
> my Ahha setup and likes the way I can go in and edit programs full
> screen either in Ahha's editor or DOS Edit. EMC offers pretty much the
> same. While converting to EMC might result in further hair loss for both
> of us, it'd most probably come out cheaper than having a service tech
> drive out to the middle of nowhere. It's sort of a back up plan if the
> control does die.
> Thanks for the input.
>
> Jon
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
Discussion Thread
Jon Anderson
2001-05-05 08:59:05 UTC
Replace Heidenhein w/ EMC?
Sven Peter, TAD S.A.
2001-05-05 14:58:07 UTC
Re: [CAD_CAM_EDM_DRO] Replace Heidenhein w/ EMC?
Jon Anderson
2001-05-05 15:09:07 UTC
Re: [CAD_CAM_EDM_DRO] Replace Heidenhein w/ EMC?
Jon Elson
2001-05-06 00:39:14 UTC
Re: [CAD_CAM_EDM_DRO] Replace Heidenhein w/ EMC?
Jon Anderson
2001-05-06 11:17:55 UTC
Re: [CAD_CAM_EDM_DRO] Replace Heidenhein w/ EMC?
Jon Elson
2001-05-06 14:24:12 UTC
Re: [CAD_CAM_EDM_DRO] Replace Heidenhein w/ EMC?
Sven Peter, TAD S.A.
2001-05-08 08:41:54 UTC
Re: [CAD_CAM_EDM_DRO] Replace Heidenhein w/ EMC?