Re: [CAD_CAM_EDM_DRO] Graphite/BP cleanup
Posted by
Sven Peter, TAD S.A.
on 2001-05-12 07:54:01 UTC
Stan
Do not dismantle the ball screw nut You will not get it back
together!!!!!!!!!!
I cleaned one some 8 days ago by unscrewing only the endplate wipers
and
pressing clean light oil and air through the oil connector and screwing
it up and down.
After a dozen times there came no more debris out and the ball screw ran
smooth again.
Good Luck
Sven Peter
[Non-text portions of this message have been removed]
Do not dismantle the ball screw nut You will not get it back
together!!!!!!!!!!
I cleaned one some 8 days ago by unscrewing only the endplate wipers
and
pressing clean light oil and air through the oil connector and screwing
it up and down.
After a dozen times there came no more debris out and the ball screw ran
smooth again.
Good Luck
Sven Peter
[Non-text portions of this message have been removed]
Discussion Thread
David Volosky
2001-05-11 07:56:05 UTC
Graphite/BP cleanup
Sven Peter, TAD S.A.
2001-05-12 07:54:01 UTC
Re: [CAD_CAM_EDM_DRO] Graphite/BP cleanup