Re: [CAD_CAM_EDM_DRO] A little bit of help; Always works!!!

Hi Anthony,

Go for it! If you don't, you'll miss out on a lot of learning. Check
out Camtronics or Gecko for the drivers, CNCpro for a controller
program, and add Sherline's mounts to a Sherline, or the appropriate
mounts for the Taig. As for a "manual", this list is better then a
manual, it's "interactive".

get ready to learn!

Alan KM6VV
P.S. Look up companies in the links/FAQ below!

Anthony Salsibruy wrote:

>
> Hi all,
> I am still undecided what to do whether to buy a ready made CNC like the Taig milling machine or to retro fit one myself. Personally I would rather build one myself, get a small milling machine and you know do it myself. But I am worried about the electronics of it and the software sides of thing!! How have people done this?? Is there any literature that anyone knows of like a step by step guide to converting a machine?? Any companies that supply the electric gubins??? And the software?? I start getting lost in it all?? Should I just buy on of these small CNC machines??
>
> Thanks for Reading!!
> Anthony