Re: Help required on steppers
Posted by
dkowalcz@i...
on 2001-06-05 09:35:16 UTC
John,
I think the 369 oz number is the right one. That's the same motor
I used on the Z axis for my lathe. Can't find my spec sheets right
now, but IIRC it was in the high 300's.
Dave Kowalczyk
Seattle WA
I think the 369 oz number is the right one. That's the same motor
I used on the Z axis for my lathe. Can't find my spec sheets right
now, but IIRC it was in the high 300's.
Dave Kowalczyk
Seattle WA
--- In CAD_CAM_EDM_DRO@y..., machines@n... wrote:
> I have been offered some steppers:-
> ******************
> Superior Electric Slo-Syn
> All new, one does not have polystyrene block packing.
> Model M092-FD-8814
> 200 oz-ins
> 200 steps per rev
> Single ended shaft
> Spec BM101029
> ***************
>
> Looking at the spec sheets at:-
> http://zone.ni.com/advisor/motion/warner.htm
> It list the M092-FD-8814's as being 261 N-cm force. That's 2.61 N-m
> which converts to 369 oz in.
>
> Can anybody shed any light on this ??
> I've checked my maths but would appreciate it if someone could
> correct me.
> Many thanks,
> John Stevenson
Discussion Thread
machines@n...
2001-06-02 15:52:59 UTC
Help required on steppers
M. SHABBIR MOGHUL
2001-06-03 22:04:56 UTC
Re: [CAD_CAM_EDM_DRO] Help required on steppers
dkowalcz@i...
2001-06-05 09:35:16 UTC
Re: Help required on steppers
M. SHABBIR MOGHUL
2001-06-28 11:15:56 UTC
Re: [CAD_CAM_EDM_DRO] Help required on steppers