Re: [CAD_CAM_EDM_DRO] Help required on steppers

hi
what type of help u required???
shabbir


************************At 10:52 PM 6/2/01 +0000, you wrote:

>I have been offered some steppers:-
>******************
>Superior Electric Slo-Syn
>All new, one does not have polystyrene block packing.
>Model M092-FD-8814
>200 oz-ins
>200 steps per rev
>Single ended shaft
>Spec BM101029
>***************
>
>Looking at the spec sheets at:-
>http://zone.ni.com/advisor/motion/warner.htm
>It list the M092-FD-8814's as being 261 N-cm force. That's 2.61 N-m
>which converts to 369 oz in.
>
>Can anybody shed any light on this ??
>I've checked my maths but would appreciate it if someone could
>correct me.
>Many thanks,
>John Stevenson
>
>
>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the

discussion of shop built systems, for CAD, CAM, EDM, and DRO.

>
>Addresses:
>FAQ: http://www.ktmarketing.com/faq.html
>FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
>Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
>List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
>Moderator: jmelson@... timg@... [Moderator]
>URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
>bill,
>List Manager
>
>FAQ: http://www.ktmarketing.com/faq.html
>
>Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>