Re: [CAD_CAM_EDM_DRO] Re: True 4 axis

At 05:30 PM 6/10/01 -0400, Chris Stratton wrote:

>Actually, the sidewalls in the latter case will not be vertical unless
>you use an endmill of zero diameter. Cutter compensation for an

Doh! See, my little gray cells are really little! :-) Of course, you and
Bill are right. My mistake (and learning experience for today!)

Best regards,

Randy (better at CAD than CAM so far...)

Randy Gordon-Gilmore ,----.___________ ______________ _________________
ProtoTrains // = = === == || == == == = || == == == = == =|
Rio Vista, CA, USA /-O==O------------o==o------------o==o-----------o==o-'
zephyrus@... http://www.rickadee.net/~zephyrus