Re: [CAD_CAM_EDM_DRO] Re: Gecko E-Stop recommended configuration

Thanks again Jon, Bill, and Tim for your hard work in moderating this fine
resource.


Tom

----- Original Message -----
From: Jon Elson <elson@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Friday, June 08, 2001 8:35 PM
Subject: Re: [CAD_CAM_EDM_DRO] Re: Gecko E-Stop recommended configuration


> Tom Eldredge wrote:
>
> > Thank you Mariss and Jon for your help on the E-stop circuitry.
> >
> > Both of you continue to be very generous in your support. Your
> > contributions have helped many people!
> > I am amazed at how many generous and knowedgable people participate in
this
> > forum. Are many other forums like this?
>
> Unfortunately, no! The Atlas-Craftsman group is pretty good, there
> are a few other specialized groups that are not too bad, but the bad
blood,
> pettiness, name-calling and bigot-baiting on many other newsgroups
> and mailing lists is just intolerable, and I have stopped reading most of
them
> due to such intolerance. It is most distressing, when people who are
interested
> in something can't have a serious discussion without people who have no
> knowledge or interest in that subject throw there venom all over the
place.
> That is what has driven communities such as ours into (semi-) moderated
> groups and lists like this, to keep the troublemakers out.

********************************************************
But, it takes effort
> for a moderator to do that, and we greatly appreciate that work!
********************************************************>
> Jon
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>