Re: Digest Number 167

Message: 12
Date: Thu, 16 Sep 1999 17:25:46 EDT
From: PTENGIN@...
Subject: Re: Re: Newbie: milling control

In a message dated 09/16/1999 9:41:24 AM Hawaiian Standard Time,
drewid@... writes:

<< It has lots of wires going from its old controller, but I'm not sure
which controls the motors, which is encoder,
limit-switch, or tachometer feedback, which controls the oiler (defunct)
and what to cut. >>
Andrew,
I will take care of it. Just send it to me.

[Ha ha ha- this thing weighs about two tons. I can only imagine what it
would cost to send it to Hawaii and back. Do you make house calls? ]

If that's not feasible, take a
picture so list members can help give pointers/advise on what to do and not
to do.
Peter
PT Engineering Co.
Honolulu Hawaii

[I can do that, and I'd appreciate any advice. I've even got a circuit
diagram, but I'm not sure how it correlates to the tangle of wires. Should
I send this stuff to you, upload it to a shared directory someplace, or put
it up on my site?]

Andrew Werby

Andrew Werby - United Artworks
Sculpture, Jewelry, and Other Art Stuff
http://unitedartworks.com