Re: [CAD_CAM_EDM_DRO] Linear Scales
Posted by
Sven Peter, TAD S.A.
on 2001-06-11 06:07:39 UTC
Yes, When in use you can blow a small amount of compressed air
into the cover (new ones have already a nipple for it).
This way nothing is supposed to get in.
Sven Peter
Paul wrote:
into the cover (new ones have already a nipple for it).
This way nothing is supposed to get in.
Sven Peter
Paul wrote:
> Hi folks[Non-text portions of this message have been removed]
>
> I have a wee problem with my lathe - After standing idle for the last few
> months, I powered it up and found I have some oil on the glass scale (Z axis).
> It is something that has happened before. I had removed it and cleaned
> everything down with alcohol, and it worked fine. I am going to have to strip
> half the carriage off to get to it again - Question is - Is there anything I
> can do to prevent it happening again ?
>
> Regards, Paul.
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
Discussion Thread
Paul Corner
1999-10-09 16:52:51 UTC
Linear Scales
Paul
2001-06-10 12:22:04 UTC
Linear Scales
Jon Elson
2001-06-10 20:16:09 UTC
Re: [CAD_CAM_EDM_DRO] Linear Scales
Sven Peter, TAD S.A.
2001-06-11 06:07:39 UTC
Re: [CAD_CAM_EDM_DRO] Linear Scales
Paul
2001-06-11 11:44:07 UTC
Re: [CAD_CAM_EDM_DRO] Linear Scales
Wally Daniels
2001-06-11 15:18:47 UTC
Re: [CAD_CAM_EDM_DRO] Linear Scales
Jon Elson
2001-06-11 20:28:49 UTC
Re: [CAD_CAM_EDM_DRO] Linear Scales