Mastercam help....
Posted by
Stephen Tate
on 2001-07-07 10:38:45 UTC
Hi All,
If there are any of you with knowledge of Mastercam I could use a little
help.
I am trying to use cutter comp in a proigram to make some side rods for a
model stem locomotive. But I keep getting the following area when I verify
the program.
"Simulated cutter compensation in control at entity 2 of 22. This is also
where the control will stop. Check for arcs with radius less than or equal
to the tool radius and for perpendicular entry/exit lines. Check q. 160 in
the .pst file."
The minimum radius in the chain is .250" (1/2 diameter). The simulation
works with a 1/8" diameter endmill but not with a 1/4" endmill. I should
only be having radius problems with 1/2 and above.
Steve Tate
(425) 481-8756
If there are any of you with knowledge of Mastercam I could use a little
help.
I am trying to use cutter comp in a proigram to make some side rods for a
model stem locomotive. But I keep getting the following area when I verify
the program.
"Simulated cutter compensation in control at entity 2 of 22. This is also
where the control will stop. Check for arcs with radius less than or equal
to the tool radius and for perpendicular entry/exit lines. Check q. 160 in
the .pst file."
The minimum radius in the chain is .250" (1/2 diameter). The simulation
works with a 1/8" diameter endmill but not with a 1/4" endmill. I should
only be having radius problems with 1/2 and above.
Steve Tate
(425) 481-8756
Discussion Thread
Stephen Tate
2001-07-07 09:56:26 UTC
Mastercam help....
Stephen Tate
2001-07-07 10:38:45 UTC
Mastercam help....
Marcus
2001-07-07 14:56:30 UTC
Re: [CAD_CAM_EDM_DRO] Mastercam help....
John Branlund
2001-07-07 17:11:18 UTC
Re: [CAD_CAM_EDM_DRO] Mastercam help....