Re: [CAD_CAM_EDM_DRO] Mastercam help....

> > "Simulated cutter compensation in control at entity 2 of 22. This is

also

> > where the control will stop. Check for arcs with radius less than or
> equal
> > to the tool radius and for perpendicular entry/exit lines. Check q. 160
> in
> > the .pst file."

This is a problem with the MasterCam verification software v7.2 and above. I
always verify with v7.0, but the same program used with v7.2 verification
produces the very same error.

If the program looks good with the toolpath-regenerate I would believe that
more than the verification.

Hope that helps.

JohnB