Servo controller and motors FS - UK only
Posted by
machines@n...
on 2001-07-14 18:07:15 UTC
Due to a masive re-think and some new machines coming on Monday I am
scrapping one of my older machines. All usefull mechanical parts
will be saved as spares for existing machines and the main castings
will be scrapped. What is left and non interchangeable is the
controller cabinet and the three motors c/w encoders.
Controller is a Siemens Simnurmec <sp> with Fanuc serco drives.
Motors are also fanuc motors. This is also known as a Fanuc 5M
controller. Controller is complete and was working when disconnected
from the machine but it's probably worth more for the power supply
and servo amps than as a complete controller.
For anybody doing a retrofit for a mill or lathe this would be ideal.
I can supply more details like motor details if required.
These are big motors off a 10 x 54 mill.
No reasonable offer refused for the lot but I can sell the motors
seperate with no problem.
John Stevenson
scrapping one of my older machines. All usefull mechanical parts
will be saved as spares for existing machines and the main castings
will be scrapped. What is left and non interchangeable is the
controller cabinet and the three motors c/w encoders.
Controller is a Siemens Simnurmec <sp> with Fanuc serco drives.
Motors are also fanuc motors. This is also known as a Fanuc 5M
controller. Controller is complete and was working when disconnected
from the machine but it's probably worth more for the power supply
and servo amps than as a complete controller.
For anybody doing a retrofit for a mill or lathe this would be ideal.
I can supply more details like motor details if required.
These are big motors off a 10 x 54 mill.
No reasonable offer refused for the lot but I can sell the motors
seperate with no problem.
John Stevenson