CAD CAM EDM DRO - Yahoo Group Archive

Re: BDI Installs, EMC/Gecko/Parallel Port interface

on 2001-07-24 17:33:16 UTC
thanks Ray,

I'm reading it!

Alan KM6VV

Ray wrote:
>
> From: Alan Marconett KM6VV <KM6VV@...>
> Subject:
> Hi Jon,
>
> I just made a new user, which I will boot into. Then I guess I need to
> give me a certain amount of privileges, if I need any more then is
> default. Thanks for the explanations.
>
> Alan
>
> There is an FAQ on using the EMC as a common user. It's in the
> www.linuxcnc.org/handbook.
>
> Ray

Discussion Thread

Alan Marconett KM6VV 2001-07-21 11:53:45 UTC Re: [CAD_CAM_EDM_DRO] BDI Installs, EMC/Gecko/Parallel Port interface Ian Wright 2001-07-21 13:29:38 UTC Re: [CAD_CAM_EDM_DRO] BDI Installs, EMC/Gecko/Parallel Port interface Jon Elson 2001-07-21 15:51:18 UTC Re: [CAD_CAM_EDM_DRO] BDI Installs, EMC/Gecko/Parallel Port interface Alan Marconett KM6VV 2001-07-21 17:28:00 UTC Re: [CAD_CAM_EDM_DRO] BDI Installs, EMC/Gecko/Parallel Port interface Alan Marconett KM6VV 2001-07-24 17:33:16 UTC Re: BDI Installs, EMC/Gecko/Parallel Port interface