RE: [CAD_CAM_EDM_DRO] Re: Introduction & request for help

Brian:

Since you're using both Stepster and DeskNC, could you please comment on
your experiences with the two.

-- Jerry Jankura
Strongsville, Ohio
So many toys, so little time

| -----Original Message-----
| From: brian [mailto:ka1bbg1@...]
| Sent: Wednesday, July 25, 2001 7:06 AM
| To: CAD_CAM_EDM_DRO@yahoogroups.com
| Subject: Re: [CAD_CAM_EDM_DRO] Re: Introduction & request for help
|
|
| Hi, i am using the hobby cnc board and the only change i made was to put a
| spdt switch so i could swap pins 11, and 15. Stepster uses pin 11
| and Desknc
| uses pin 15 if memory serves me correctly. it is mentioned in the
| paperwork.
| cul brian f.
|