Re: [CAD_CAM_EDM_DRO] LPT port control software

hi
u can use CNCPRO for this. this will work in dos mode and loads g-code
files then works

shabbir


******************At 09:23 AM 7/20/01 +0200, you wrote:

>Hi All
>I am busy writing some software for my foam cutter, can anyone direct me to
>some VB source code for controlling steppers from the lpt port. This could
>save a stack of time. I have managed to write the DXF import routines and
>can thus far create G-code from a DXF file, it was a long process but the
>achievement was worth it (part of the hobby).
>
>Thanks
>
>
> Coert vd Sandt
>
>Addresses:
>FAQ: http://www.ktmarketing.com/faq.html
>FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
>Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
>List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
>Moderator: jmelson@... timg@... [Moderator]
>URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
>bill,
>List Manager
>
>
>
>Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>