CAD CAM EDM DRO - Yahoo Group Archive

Re: Re: g-code to dxf

Posted by IMService
on 2001-07-26 07:02:46 UTC
>Message: 12
> Date: Wed, 25 Jul 2001 19:38:30 -0700
> From: Alan Marconett KM6VV <KM6VV@...>
>Subject: Re: g-code to dxf


>But check to see if the CAD-only vers. can do this too! I'll be looking
>tonight, or ask Fred! I don't think it's a slam-dunk, but Vector CAD is
>worth it anyway, and then you can try some files! I have done a limited
>amount of Gcode TO DXF with Vector CAD/CAM. I couldn't get around
>G17/18/19 exchanges. 2D probably easier!
>

The Cad-only version will not backplot G-code to a drawing.
Find, Replace, and renumber are enabled, as are the Macros.

Vector will backplot g-code feed and rapid moves, including 3D arcs. It may
have a problem with arcs that are greater than 180 degrees. It does recognize
G17-18 & 19.It can draw lines to indicate the drilled points in cycles by
replacing the cycle with G01. Then Draw points at the end of each line.

It will also backplot Heidenhein code.

Best Regards, Fred Smith- IMService
Listserve Special discounts and offers are at: http://209.69.202.197/cced.html

imserv@... Voice:248-486-3600 or 800-386-1670 Fax: 248-486-3698

Discussion Thread

Tom Murray 2001-07-25 07:06:51 UTC g-code to dxf M. SHABBIR MOGHUL 2001-07-25 09:43:44 UTC Re: [CAD_CAM_EDM_DRO] g-code to dxf Alan Marconett KM6VV 2001-07-25 12:27:09 UTC Re: [CAD_CAM_EDM_DRO] g-code to dxf Tom Murray 2001-07-25 18:15:49 UTC Re: g-code to dxf Alan Marconett KM6VV 2001-07-25 19:37:22 UTC Re: g-code to dxf IMService 2001-07-26 07:02:46 UTC Re: Re: g-code to dxf Alan Marconett KM6VV 2001-07-26 12:03:03 UTC Re: g-code to dxf M. SHABBIR MOGHUL 2001-07-26 12:25:07 UTC Re: [CAD_CAM_EDM_DRO] Re: g-code to dxf