Re: g-code to dxf

Thanks Fred,

The quick try of some G17/18/19 code I tried was cutting FULL circles,
so that's why it didn't import!

I thought Heidenhein was Gcode! Much different?


Alan KM6VV
(still going in FULL circles)

IMService wrote:

>
> >Message: 12
> > Date: Wed, 25 Jul 2001 19:38:30 -0700
> > From: Alan Marconett KM6VV <KM6VV@...>
> >Subject: Re: g-code to dxf
>
> >But check to see if the CAD-only vers. can do this too! I'll be looking
> >tonight, or ask Fred! I don't think it's a slam-dunk, but Vector CAD is
> >worth it anyway, and then you can try some files! I have done a limited
> >amount of Gcode TO DXF with Vector CAD/CAM. I couldn't get around
> >G17/18/19 exchanges. 2D probably easier!
> >
>
> The Cad-only version will not backplot G-code to a drawing.
> Find, Replace, and renumber are enabled, as are the Macros.
>
> Vector will backplot g-code feed and rapid moves, including 3D arcs. It may
> have a problem with arcs that are greater than 180 degrees. It does recognize
> G17-18 & 19.It can draw lines to indicate the drilled points in cycles by
> replacing the cycle with G01. Then Draw points at the end of each line.
>
> It will also backplot Heidenhein code.
>
> Best Regards, Fred Smith- IMService
> Listserve Special discounts and offers are at: http://209.69.202.197/cced.html
>
> imserv@... Voice:248-486-3600 or 800-386-1670 Fax: 248-486-3698
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/