Re: CAD/CAM software

Frank,

Model Mill is a program by Artistic Automation in Eastlake, CO. Their phone
number is 303-452-8788.

Bob Campbell

----- Original Message -----
From: F. de Beer <f.debeer@...>
To: <CAD_CAM_EDM_DRO@onelist.com>
Sent: Thursday, September 23, 1999 4:12 AM
Subject: Re: [CAD_CAM_EDM_DRO] CAD/CAM software


> From: "F. de Beer" <f.debeer@...>
>
> Bob,
>
> I know Rhino, but I can't find Model Mill on the net. Can you give more
> details?
>
> Frank
>
>
>
> >
> > One of the best low cost solutions is to use Rhino 3D for the modeling
and
> > Model Mill for the G code output. Model Mill is about $3,00 and Rhino
is
> at
> > least $750. This may be more that you want to pay, but is a good
> > combination.
> >
> > Bob Campbell
>
>
>
> > Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems in the above catagories.
> To Unsubscribe, read archives, change to or from digest.
> Go to: http://www.onelist.com/isregistered.cgi
> Log on, and you will go to Member Center, and you can make changes there.
> For the FAQ, go to http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>