Re: 486 & EMC or CNCPro

Hi Peter,

Well, I believe you can find it on this list!

Alan KM6VV

cadcamcenter@... wrote:

>
> From: Alan Marconett: <I had a 400 Mhz Pentium machine with Windoz98
> on it, in several partitions (6 Gb drive). I was able (with list
> help) to install BDI over it, "taking over" one of my unused
> partitions, and letting BDI reformat it for Red Hat. In the boot up,
> you press TAB (quickly), and you can select DOS or Linux. Ray, Ian,
> and others provided quite a bit
> of help on the list, you might check back a week or two for past
> posts.>
>
> I have lots of "old" computers, I assume most working, in MY new
> workshop, some of them P class I believe. If I run into any trouble,
> expect lots of questions, begging for help from me!!!!
>
> Peter