Re: [CAD_CAM_EDM_DRO] Question, dimensions for #23 steppers

Hi Jon,

I measured two different Sanyo Denki, and some SloSyn steppers. Also
two sets of motors from MaxNC's "motion control kit", All were under
0.8" Some of the Sanyo Denki's did have tapped flange holes (?).

Are you planning to sell a mounting kit? Flex coupling? I'd be
interested in hearing more about it!

Alan KM6VV

Jon Anderson wrote:

>
> I'm working on a much revised thrust plate setup for the MaxNC mills.
> Trying to compact things as much as possible, I designed around the
> couple motors I have laying around here, some PacSci motors.
> I measure the shaft extension from the mounting face at about .800, and
> have designed accordingly. Before I commit anything to metal, wanted to
> ask, is anyone aware of any commonly found N23 motors with shafts that
> extend beyond this? I'd think that adhering to a standard would insure
> this IS the standard, but standards just don't always seem to be, well,
> standard...
>
> Thanks,
>
> Jon A.