CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Steppers vs Sevrvos?

Posted by Ron Yost
on 2001-08-07 20:08:37 UTC
At 05:00 7:24 PM 8/7/01 , you wrote:
>Thank you all for you info with regards to this post.
>
>I think I will stick with steppers for the time being, as the project is
>for 7x12
>mini lathe the servo route may be a bit of an overkill!

Stephen,

Are you aware of the '7x10minilathe' group on Yahoogroups?
Knowledgeable and very helpful bunch of folks .. they cover the 7x12's
and Minimill's also.

Ron Yost

Discussion Thread

Stephen Goldsmith 2001-08-06 16:56:20 UTC Steppers vs Sevrvos? info.host@b... 2001-08-06 17:51:25 UTC Re: [CAD_CAM_EDM_DRO] Steppers vs Sevrvos? Carol & Jerry Jankura 2001-08-06 18:43:42 UTC RE: [CAD_CAM_EDM_DRO] Steppers vs Sevrvos? Jon Elson 2001-08-06 20:46:44 UTC Re: [CAD_CAM_EDM_DRO] Steppers vs Sevrvos? Dan Mauch 2001-08-07 06:39:26 UTC RE: [CAD_CAM_EDM_DRO] Steppers vs Sevrvos? JanRwl@A... 2001-08-07 15:10:04 UTC Re: [CAD_CAM_EDM_DRO] Steppers vs Sevrvos? Stephen Goldsmith 2001-08-07 17:03:39 UTC Re: [CAD_CAM_EDM_DRO] Steppers vs Sevrvos? Ron Yost 2001-08-07 20:08:37 UTC Re: [CAD_CAM_EDM_DRO] Steppers vs Sevrvos? brian 2001-08-08 05:22:31 UTC Re: [CAD_CAM_EDM_DRO] Steppers vs Sevrvos?